3 1/2"  Round - Used in late 60's and early 70's Cadillac, early 70's Olds, Pontiac, Buick and late 60's, early 70's Mopar front 3 speaker dash locations for stereo radio/tape applications. The mounting ears can be cut off and the speaker held in with the wire clips used on many GM applications(See photo below). We can supply a magnet filler block on request for cars using the Delco wire clip mount.

Note: When used with modern high power radios, this speaker should be connected with 50uf 50volt non-polar coupling capacitors in series to prevent over excursion of the cone at very low frequencies. Some factory GM and all Mopar applications using these speakers have the crossover capacitors installed in a box under the dash. It is even more important when installed with our conversion radios or modern after market radios with high power amplifiers. 


8 - 10 Ohm

Size: 3 3/8" dia.

1 1/2" deep

3 3/4" to 4 1/4" mounting center.

3 1/2" Round Speaker

    56 f100 knob front.jpg
    1956 Ford F100 Radio Dial Knob